A-WALL vs. Permanent Construction
Buildings for People, Process and Product
A-WALL Buildings in Action
Standard, Poly-Core and EPS Core Panels
Single Story Bldgs. up to 9' High
Single Story Bldgs. of Unlimited Size
Two-Story Buildings
Outdoor Buildings
Portable, Forkliftable Buildings
Buildings Above and/or Below Mezzanines
Demountable, Floor-to-Ceiling Partitions
Typical Building Configurations
Pre-Engineered, Standard Sizes
Complete Building Wiring Packages
Air Conditioners, Doors, Windows and More
Planning and Design Tools
GSA Contract & Contact Information
Home

A-WALL Electrical Packages

Complete electrical wiring packages are available for your A-WALL in-plant building. They include a main breaker panel, 2’ x 4’ recessed, grid type light fixtures, switches, receptacles and empty utility boxes with pull wires for data and phone wiring. The receptacles, switches and data boxes are pre-installed and factory wired to the tops of the wall panels. An optional, FLEX-4 modular wiring system is also available for even greater flexibility and speed of assembly (see below).

Unlike many modular building systems that limit wiring to hollow posts at the panel connections, standard A-WALL panels are equipped with three independent wiring cavities. This allows you to specify ganged switches and receptacles, as well as phone and data boxes, all in the same panel. If additional devices are required after the building is installed, these cavities facilitate concealed wiring using common, “off-the-shelf” boxes and conduit.

Panel Wiring Options  

Factory Pre-Wire Package
Switches and receptacles are factory installed and wired in accordance with the National Electrical Code. A Pigtail with box connector is provided above each device at the ceiling plenum. Data/phone device boxes are factory installed in the panels with pull wires at the ceiling plenum for ease of wiring on-site. An electrician is only required to mount, power and wire the breaker panel to the pigtails and lights above the suspended ceiling. The only material that must be provided by the electrician is the conduit and wire above the ceiling, and the tubes for the lights.

 Factory Pre-wire detail
   

FLEX-4 Modular Wiring Package
Switches, receptacles and lights are factory wired and equipped with U.L. listed, “snap together” cables. All cables necessary to connect these devices to the breaker panel are provided for the building installer. An electrician is only required to mount, power and wire the breaker panel to the FLEX-4 distribution cables. The electrician must also provide the tubes for the lights.

 FLEX-4 Modular Wiring detail
Request Quotation Request Information
Request Quotation Request Information

COMPONENT SYSTEMS, INC. 800-345-4400
Toll Free FAX: 888-432-9274

Home

Copyright © 2000 Component Systems, Inc. All rights reserved.